clean + easy Facial Waxer
Just plug in the clean + easy Facial Waxer, and it is ready in 15 minutes!
SKU: 001310 /
Guaranteed AuthenticGuaranteed Authentic
Folica is an authorized distributer of this product and guarantees its authenticity.Close
- Removes unsightly hair from eyebrows, upper lip and chin
- The clean, fast and easy way to remove hair for up to 6 weeks
- Hair regrowth is finer and sparser
- Small and convenient size-great for travel
It may take a few sessions with your waxing unit and wax applicator to become proficient. For the best results, be sure to read all instructions thoroughly before waxing. All it takes is a little patience to learn the right way to wax and get the results you want.
FOR BEST RESULTS: Before using any new product on your skin, always patch test a small, less noticeable section of the area you are going to wax. If there is no adverse reaction after 24 hours you may continue. Hair should be about ½ inch (6mm) long before waxing. Wax only a small area at a time until you are familiar with the process. Room temperature should be at least 75F. Heat applicator in waxing unit for 15 to 20 minutes with cover on the waxing unit. Variations in electrical service may lengthen the heat-up time. The wax applicator is ready to use if you see air bubbles rising easily to the top when you invert the applicator. If you do not, return the applicator to the waxing unit for additional heating. Wait at least two hours after bathing or showering before waxing to prevent skin irritation.
PREPARATION: Attach roller head to wax applicator after removing plug and place in waxing unit. Replace waxing unit cover and plug waxing unit into outlet. Allow wax to warm for15-20 minutes. Do not overheat. (Note: clean+easy Wax applicator is designed to be heated in this waxing unit only). Do not heat wax or heater in microwave, any other oven or on stovetop. Before waxing, cleanse skin with soap and water to remove oil, make-up or perspiration, but do not bath or shower less than 2 hours before waxing. Dry skin thoroughly. Always apply a light dusting of talcum powder before waxing.
GENERAL DIRECTIONS FOR APPLYING WAX: To start new rollers flowing smoothly prior to waxing, remove applicator from waxing unit and turn upside down. Wait a few seconds to allow air bubbles to rise and wax to flow into the roller head. Hold applicator by the sides at a 45 degree angle. Always roll in the direction of hair growth.
Roll in one smooth motion. Do not roll back and forth. One thin coat of wax is all that is necessary. Do not squeeze applicator. After applying wax, return applicator to waxing unit. Keep unit plugged in until waxing session is complete. Always close cover to maintain proper wax temperature.
REMOVING WAX: Apply wax remover strip and rub briskly in direction of hair growth for 3-4 seconds. With one hand, hold the skin taut. With the other hand, pull off the strip in the opposite direction of growth. Use one quick motion parallel to the skin.
AFTER WAXING: If any wax residue remains on your skin, re-apply the wax remover strip, rub firmly and remove as usual. Apply clean+easy After Wax Cleanser over area, rubbing lightly for a few minutes. Repeat if necessary until wax wipes off with a damp cloth. Do not try to remove wax by washing with water. After use, return applicator to your waxer, close the cover and unplug. Allow your waxer to cool then store upright.
WARNING: Do not wax inside nose, ears, on nipples, eyelashes, warts, and moles or near genital areas. Do not use if you have varicose veins, diabetes, phlebitis, chapped, sore or sunburned skin, recent scar tissue, eczema or any other skin disorder. Do not use if you are using Retin-A, Accutane, Glycolic Acid, Alpha Hydroxy treatments or Steroids.
DO NOT HEAT WAX OR PLACE HEATER IN MICROWAVE OVEN OR ON STOVETOP. DO NOT WAX IF YOU ARE USING RETIN-A, ACCUTANE, GLYCOLIC ACID, ALPHA HYDROXY TREATMENTS, OR STEROIDS.
FOR EXTERNAL USE ONLY
KEEP OUT OF REACH OF CHILDREN