Satin Smooth Nice 'N Neat Large Zinc Oxide Wax Replacement Cartridges
Satin Smooth Nice 'N Neat Large Zinc Oxide Wax Replacement Cartridges are recommended for acne and blemish prone skin.
SKU: 002911 /
Folica is an authorized distributer of this product and guarantees its authenticity.Close
- Ultra-sensitive Zinc Oxide, easy spread formula
- Formulated for thin skin and fair complexions
- Recommended for acne and blemish prone skin
- Large cartridge for body waxing
- Ideal for fine to medium hair
- Turns skin to silk
Remove wax container lid before placing into hand-held warmer. Place wax cartridge container into hand-held warmer pressing down firmly so that the entire cartridge fits deep into the heating chamber. Turn on the Satin Smooth Nice N Neat Single Cartridge Wax Warmer to the maximum high setting. This will produce a rapid heat up and melt wax quickly. Once wax is melted turn the dial down to medium. Allow 20-30 minutes for the wax to stabilize to a usable temperature before applying to skin. Never apply the wax on the skin if the warmer has been left on high. Test the wax on a large non-woven cloth strip. Hold until upside down or at a 45 degree angle. Apply wax from the top to the bottom of the cloth. If the wax applies easy to the cloth, it is ready to be used.
For best results body hair should be at least 1/4 inch. Do not use cream or body lotion before waxing. Ensure that the skin is clean and dry. Skin may be cleansed using Satin Smooth Skin Preparation Cleanser . Always test a small amount of wax for proper temperature on the inside of your wrist before waxing application begins. Hold applicator upside down at a 45 degree angle and apply wax following hair growth. Satin Smooth Nice N Neat Roller Heads will allow you to apply the wax thinly and neatly. Place one strip over the waxed area and press down firmly with the palm of your hand. Hold the skin taut and peel the strip sharply away in one quick movement, against the direction of hair growth. Should any hair remain, reapply the same wax coated strip and remove as described before. Repeat until the entire area being treated is free from hair. If some wax remains on the skin, remove using Satin Smooth Satin Release Wax Residue Remover. After finishing a section apply Satin Smooth Satin Cool Aloe Vera Smoothing Gel to reduce any discomfort, then apply Satin Smooth Satin Hydrate Skin Nourisher evenly over the area and massage in.
Turn the warmer off and unplug. Remove the cartridge from the warmer and clean both the heater and the outer surface of the wax container with Satin Smooth ReMovelt All Purpose Cleaner. The partially used wax container can be stored in the warmer. with the warming unit cover in place to protect from dust and foreign elements.
Glyceryl Roinate, Paraffinum Liquium, Cera Alba, Cera Microcristallina