using the chi
submitted by: kim, Wed Feb 02 2005
17 of 24 people found this tip helpful.
when using the chi, use small sections, run the flat iron through the hair at a faster pace then you would a cheap iron and here is the key: use a comb following the iron, not a wide tooth comb or a brush. using the comb helps get your hair as straight as possible.
Wait for it to get hot before using... but not too hot!
submitted by: hilary, Sat Dec 18 2004
5 of 16 people found this tip helpful.
Wait for it to get hot before using... but not too hot! If its too hot it seems like it will burn your hair -- even with the covering (that you pay $120 for!) it gets hot!
Use a serum
submitted by: Cassandra, Sat Nov 27 2004
25 of 38 people found this tip helpful.
For those of you that are not familiar with CHI iron, it will obviously damage your hair if you don't use a serum before use. So use a serum and take care of it!
When your hair is wet
submitted by: Kaylo, Fri Nov 26 2004
5 of 8 people found this tip helpful.
While hair is wet you use a frizz control product.
Flat Iron Spray
submitted by: Penny, Tue Nov 16 2004
29 of 33 people found this tip helpful.
To prevent hair damage from the heat, use flat iron spray to protect the hair like Biosilk or Lustrasilk Smooth Ends Leave In Conditioner.
|
